Removal Procedure
- Disable the SIR system. SIR Disabling and Enabling
- Instrument Panel Knee Bolster - Remove - Instrument Panel Knee Bolster Replacement (Left Side) , or Instrument Panel Knee Bolster Replacement (Right Side)
- CAUTION:
With wheels of the vehicle facing straight ahead, secure the steering wheel utilizing steering column anti-rotation pin, steering column lock, or a strap to prevent rotation. Locking of the steering column will prevent damage and a possible malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:
- The steering column
- The intermediate shaft (s)
- The steering gear
After disconnecting these components, do not rotate the steering wheel or move the front tires and wheels. Failure to follow this procedure may cause the SIR coil assembly to become un-centered and cause possible damage to the SIR coil. If you think the SIR coil has became un-centered, refer to your specific SIR coil's centering procedure to re-center SIR Coil.
Install the CH-42640 Steering Column Anti-Rotation Pin (1) in the steering column lower access hole.
Transmission shift cable (1) @ Steering Column - Disconnect
Electrical Connector (1) @ Steering Column - Disconnect
- {If equipped, disconnect the steering wheel position sensor electrical connector}.
- Remove the wiring harness retaining pin from the bottom of the steering column.
Remove the upper intermediate steering shaft nut and bolt (1).
- Upper Intermediate Steering Shaft (2) @ Steering Column (3) - Remove
Remove the steering column nuts (1) [4x].
- CAUTION:
Once the steering column is removed from the vehicle, the column is extremely susceptible to damage. Dropping the column assembly on the end could collapse the steering shaft or loosen the plastic injections, which maintain column rigidity. Leaning on the column assembly could cause the jacket to bend or deform. Any of the above damage could impair the columns collapsible design. Do NOT hammer on the end of the shaft, because hammering could loosen the plastic injections, which maintain column rigidity. If you need to remove the steering wheel, refer to the Steering Wheel Replacement procedure in this section.
Remove the steering column from the vehicle. (1)
- Transfer components as necessary.
Refer to SIR Warning .
During removal of the steering column the wire harness retaining clip must be removed and reinstalled after installing the steering column or damage may occur to the wire harness.