Terminal Insertion Procedure

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.

After the terminal is replaced, perform the following procedure in order to insert the terminal.

Slide the new terminal into the correct cavity at the back of the connector.
Push the terminal into the connector until it locks into place. The new terminal should be even with the other terminals. Ensure that the terminal is locked in place by gently pulling on the wire.
Courtesy of GENERAL MOTORS COMPANY

Locate the TPA.
Courtesy of GENERAL MOTORS COMPANY

Use a small flat-blade tool to push the TPA until it bottoms out.
Courtesy of GENERAL MOTORS COMPANY

Ensure the TPA is fully seated. The TPA should be centered and flush with the connector body when viewed.