Terminal Removal Procedure

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to repair push to seat connectors.

Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
Courtesy of GENERAL MOTORS COMPANY

Separate the connector halves (1).
Courtesy of GENERAL MOTORS COMPANY

Use the proper pick or removal tool (1) in order to release the terminal.
Gently pull the cable and the terminal (2) out of the back of the connector.
Courtesy of GENERAL MOTORS COMPANY

Re-form the locking device if you are going to reuse the terminal (1).
Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair) , or Repairing Connector Terminals (Terminal Repair) procedure.
Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.