Fastener Specifications
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Lower Control Arm Ball Stud Nut | |
|
65 N.m (48 lb ft) |
|
60 - 75 degrees |
| Front Lower Control Arm Nut (with C7I) | |
|
120 N.m (89 lb ft) |
|
165 - 185 degrees |
| Front Lower Control Arm Nut (without C7I) | 155 N.m (114 lb ft) |
| Front Shock Absorber Bolt | 25 N.m (18 lb ft) |
| Front Shock Absorber Nut | 22 N.m (16 lb ft) |
| Front Stabilizer Shaft Insulator Clamp Bolt | 50 N.m (37 lb ft) |
| Front Stabilizer Shaft Insulator Clamp Nut | 46 N.m (34 lb ft) |
| Front Stabilizer Shaft Insulator Clamp Stud | 25 N.m (18 lb ft) |
| Front Stabilizer Shaft Link Bolt | 11 N.m (97 lb in) |
| Front Upper Control Arm Ball Stud Nut | |
|
25 N.m (18 lb ft) |
|
90 - 100 degrees |
| Front Upper Control Arm Nut | 175 N.m (129 lb ft) |
| Front Wheel Bearing Bolt | 180 N.m (133 lb ft) |
| Front Wheel Hub Extension Nut | 130 N.m (96 lb ft) |