LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Automatic Transmission - 6L90 (MYD) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the parking brake.
  2. Position the steering column shift lever to park.
  3. Remove the instrument knee bolster bracket. Instrument Panel Knee Bolster Bracket Replacement (Left Side) , or Instrument Panel Knee Bolster Bracket Replacement (Right Side)
  4. GM4602055Courtesy of GENERAL MOTORS COMPANY

    Remove the clip (3) securing the shift cable to the steering column bracket.

  5. Remove the shift cable (1) from the steering column shift control (2).
  6. Remove the body hinge pillar trim panel. Body Hinge Pillar Trim Panel Replacement
  7. Remove the front side door step mat. Front Side Door Step Mat Replacement
  8. Pull back the carpet and insulation to gain access to the shift cable pass-through grommet.
  9. GM4602081Courtesy of GENERAL MOTORS COMPANY

    Remove the rubber grommet (2) from the floor panel.

  10. Disconnect the retainer (1).
  11. Raise the vehicle. Lifting and Jacking the Vehicle
  12. GM4842577Courtesy of GENERAL MOTORS COMPANY

    Remove the shift cable (2) from the shift lever (3).

  13. Remove the locking clip (1) from the cable at the bracket.
  14. Lower the vehicle.
  15. Remove the shift cable from the vehicle.
scientia non olet · About LEMON Manuals