LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Engine Controls And Fuel - 2.8L (LWN) Diesel - Repair Instructions) >> Repair Instructions >> Fuel Injection Pump Metering Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (Single Battery) , or Battery Negative Cable Disconnection and Connection (Dual Battery)
  2. Engine Mount Bracket-Left Side - Remove - Engine Mount Bracket Replacement - Left Side
  3. GM4854948Courtesy of GENERAL MOTORS COMPANY

    Disconnect the electrical connector (1).

  4. GM4854539Courtesy of GENERAL MOTORS COMPANY

    Remove the fuel feed and return harness bracket nut (1).

  5. Remove the fuel feed hose protector bolt (2).
  6. Remove the fuel feed hose protector (3).
  7. GM4854567Courtesy of GENERAL MOTORS COMPANY

    Remove the fuel injection pump metering valve fasteners (1).

  8. Remove the fuel injection pump metering valve (2).

    Remove and DISCARD the fuel injection pump metering valve o-ring seal. The seal is NOT shown.