Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Install the transmission fluid cooler inlet and outlet pipe (1) to the vehicle.
- Remove the caps from the fittings and plugs from the holes before installing the transmission fluid cooler pipes.
- Transmission Fluid Cooler Pipe Fitting Seal (2) - Install a NEW seal.[2x]
- Transmission Fluid Cooler Inlet and Outlet Pipe (1) - Install
- Transmission Fluid Cooler Inlet and Outlet Pipe Retainer (3) - Install
- Transmission Fluid Cooler Inlet and Outlet Pipe Bolt (4) - Install and tighten22 N.m (16 lb ft)
Transmission Fluid Cooler Inlet and Outlet Pipe (2) @ Transmission Fluid Cooler Pipe Bracket (2) - Clip[2x]
Transmission Fluid Cooler Inlet and Outlet Pipe (1) @ Transmission Fluid Cooler Pipe Bracket - Clip[2x]
Transmission Fluid Cooler Inlet and Outlet Pipe (2) @ Radiator - Engage[2x] - Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection
- Transmission Fluid Cooler Pipe Clip (1) @ - Engine Coolant Fan Shroud - Clip
Front Wheelhouse Splash Shield-Right Side (1) - Install - Wheelhouse Splash Shield Replacement (Left Side)Wheelhouse Splash Shield Replacement (Right Side)
- Check the transmission fluid level. Transmission Fluid Level and Condition Check
- Inspect for transmission fluid leaks.
- Remove the drain pan.
CAUTION:
Refer to Fastener Caution