Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Route the transmission fluid cooler pipe (2) into proper position.
- Transmission Fluid Cooler Pipe (2) @ Transmission Fluid Cooler Pipe Clip (3) - Install
- Transmission Fluid Cooler Pipe (2) @ Transmission Fluid Cooler Pipe Clip (1) - Install
- NOTE:
Remove the caps from the fittings and plugs from the holes before installing the transmission fluid cooler pipes.
Transmission Fluid Cooler Pipe Fitting Seal (2) - Install a NEW seal.
- Transmission Fluid Cooler Pipe (3) @ Transmission - Install
- Transmission Fluid Cooler Pipe Bolt (1) @ Transmission Install and tighten22 N.m (16 lb ft)
Transmission Fluid Cooler Pipe (1) @ Transmission Fluid Cooler Pipe Clip (2) - Engage
- Transmission Fluid Cooler Pipe (1) @ Transmission Fluid Auxiliary Cooler - Install - Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection
- NOTE:
Cap the openings to prevent contamination.
Transmission Fluid Cooler Pipe (1) @ Radiator (2) - Install - Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection
- Front Grille - Install - Front Grille Replacement (Chevrolet)Front Grille Replacement (GMC)
- Check the transmission fluid level. Transmission Fluid Level and Condition Check
- Inspect for transmission fluid leaks.
- Remove the drain pan.
CAUTION:
Refer to Fastener Caution
NOTE:
Remove the caps from the fittings and plugs from the holes before installing the transmission fluid cooler pipes.