LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Automatic Transmission - 8L90 (M5U) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P071A >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.

For an overview of the component/system, refer to: Tow/Haul Mode Description and Operation

Circuit Description
Signal The control module input circuit has an internal resistance connected to 12 V.
Ground Chassis Ground
Component Description
K9 Body Control Module The control module contains a microprocessor used to process input data to control outputs.
K71 Transmission Control Module The control module contains a microprocessor used to process input data to control outputs. The control module receives information from a variety of sensors, switches and serial data information from other control modules. This information is used to control a combination of solenoid valves to obtain the correct line pressure, gear ratio and torque converter clutch operation.
S2 Transmission Manual Shift Switch The switch S2 has an internal resistor ladder network. A specific resistance is generated dependent on the position of the switch.
scientia non olet · About LEMON Manuals