Component Testing
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition/Vehicle - Off
- Remove the component: Automatic Transmission Fluid Pan
- Remove the component: Control Valve Assembly
- Disconnect the electrical connector: X176
- Test for 65 to 47, 000 ohms between the test points: Signal circuit terminal 14 & Low Reference terminal 16 @ X176
- If not between 65 and 47, 000 ohms
Replace the component: B13 Transmission Fluid Temperature Sensor
- Go to next step: If between 65 and 47, 000 ohms
- If not between 65 and 47, 000 ohms
- All OK.
NOTE:
Testing for steps 4 to 7 is performed on the component side of the harness connector.