LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Automatic Transmission - 6L90 (MYD) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Noise in First or Reverse Gear

Noise in First or Reverse Gear

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Checks Causes
Center Support with 2 - 6 Low and Reverse Clutch Assembly (67)
  • Inspect for damaged or worn low and reverse clutch plates (463 - 465).
  • Inspect for damaged low and reverse clutch backing plate (462). Inspect for worn splines on backing plate.
  • Inspect for damaged low and reverse clutch backing plate retaining ring (461).
  • Inspect for damaged low and reverse clutch piston assembly (470), spring (469), spring retaining ring (466), and center support assembly (459).
  • Inspect for damaged low clutch sprag assembly (467). Holding the sprag assembly with the retaining ring facing up, and the inner race of the sprag assembly fixed, the outer race should freewheel counterclockwise.
  • Inspect for cut, worn, or damaged low clutch sprag seal (468).
Output Carrier Assembly (68) Inspect for damaged or stripped splines on the output carrier assembly.