LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Automatic Transmission - 6L90 (MYD) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Harsh Garage Shift

Harsh Garage Shift

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Checks Causes
NOTE:

On cold days, approximately 32°F (0°C) or colder, the transmission is designed to shift differently. The transmission uses a warm-up mode shift schedule until the engine reaches normal operating temperature. While the transmission is in warm-up mode, it is normal for transmission upshifts to be delayed or held longer. This feature improves heater performance by giving quicker vehicle warm-ups.

Engine Elevated engine RPM - Verify correct engine operating rpm per application.
F
Automatic Transmission Fluid Pump Cover(219)
  • Inspect for damaged, stuck, sticky pressure regulator valve (233) and springs (234 and 235).
  • Inspect for damaged, stuck, sticky isolator valve (236) and sleeve (237).
Control Valve Solenoid Body(314)
  • Incorrect or inadequate adapt activity - Perform Reset Transmission Adapts  procedure.
  • Incorrect TCM temperature reporting - Monitor TCM temperature using a scan tool.
  • Line pressure control solenoid incorrect pressure.
1-2-3-4 and 3-5-Reverse Clutch(51)
  • Inspect for damaged 1-2-3-4 clutch piston (414), piston housing (417), spring (413), and dam assembly (412).
  • Inspect for cut, worn, or damaged 1-2-3-4 clutch piston seal (416), inner seal (423), and housing seals (424 and 425).
  • Inspect for improper selective 1-2-3-4 clutch backing plate retaining ring (429).
  • Inspect for damaged 3-5-R clutch piston (421), apply ring (405), and spring (420).
  • Inspect for cut, worn, or damaged 3-5-R clutch piston dam O-ring seal (418), inner seal (419), and outer seal (422).
  • Inspect for improper selective 3-5-R clutch backing plate retaining ring (400).