LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Automatic Transmission - 6L90 (MYD) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0872 or P0873 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - Off
  2. Remove the component: Q8 Control Solenoid Valve Assembly
  3. Install & SetupSpecial ToolDT-47825-10
  4. Connect the tool between the test points: Q8 Control Solenoid Valve Assembly & Wiring Harness@Vehicle
  5. Use a suitable tool.Press and hold the switch - Transmission Fluid Pressure Switch
  6. Verify the scan tool parameter changes
    • Transmission Fluid Pressure Switch 1
    • Transmission Fluid Pressure Switch 2
    • Transmission Fluid Pressure Switch 4
    • Transmission Fluid Pressure Switch 5
    • If the parameter state does not change 

      Replace the component: Q8 Control Solenoid Valve Assembly

    • Go to next step: If the parameter state changes 
  7. Verify a condition does not exist with the component: Filter Plate Assembly
    • If a condition exists 

      Clean the components as necessary.

    • Go to next step: If no condition exists 
  8. All OK.
scientia non olet · About LEMON Manuals