LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Engine Controls And Fuel - 2.8L (LWN) Diesel - Diagnostic Information And Procedures (2 Of 3)) >> Diagnostic Information and Procedures >> DTC P1089 >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.

The Engine Control Module (ECM) monitor s for changes in fuel rail pressure when the vehicle is in a deceleration condition and the fuel injected quantity is at zero. When scan tool parameter Deceleration Fuel Cut-Off is active, the fuel rail pressure should not deviate more than 2 MPa (290 PSI) from a calculated setpoint. If the fuel rail pressure deviates more than 2. MPa (290 PSI) from the calculated setpoint for approximately 10 seconds of cumulative deceleration (this may take multiple drive cycles), the DTC will set.

scientia non olet · About LEMON Manuals