LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Engine Controls And Fuel - 2.8L (LWN) Diesel - Diagnostic Information And Procedures (2 Of 3)) >> Diagnostic Information and Procedures >> DTC P1048, P1049, or P2047-P2049 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Perform the scan tool control function: Reductant Injector - On and Off
  3. Verify a click can be heard or felt at the component when the scan tool control function was commanded: Q61 Reductant Injector
    • If a click cannot be heard or felt 

      Refer to: Circuit/System Testing

    • Go to next step: If a click can be heard or felt 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  5. All OK.
scientia non olet · About LEMON Manuals