Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Fuel Feed and Evaporative Emission Rear Pipe (3) - Install
- Evaporative Emission Pipe(2) - Connect - Plastic Collar Quick Connect Fitting Service
- Fuel Feed Pipe(1) - Connect - Plastic Collar Quick Connect Fitting Service
Retainer(2) - Install
- Fuel Feed and Evaporative Emission Rear Pipe Bolt (1) - Install and tighten8.5N.m (75 lb in)
Retainer(2) - Install[2x]
- Fuel Feed and Evaporative Emission Rear Pipe Bolt (1) - Install and tighten[2x]8.5N.m (75 lb in)
Retainer(2) - Install[2x]
- Fuel Feed and Evaporative Emission Rear Pipe Bolt (1) - Install and tighten[2x]8.5N.m (75 lb in)
Retainer(3) - Install
- Fuel Feed and Evaporative Emission Rear Pipe Bolt (2) - Install and tighten8.5N.m (75 lb in)
- Evaporative Emission Pipe(1) - Connect - Plastic Collar Quick Connect Fitting Service
Fuel Feed Pipe(1) - Connect - Metal Collar Quick Connect Fitting Service
- Fuel Pressure Sensor - Connect - Fuel Pressure Sensor Replacement (Short Wheel Base) , or Fuel Pressure Sensor Replacement (Long Wheel Base) , or Fuel Pressure Sensor Replacement (Chassis Cab Front Tank) , or Fuel Pressure Sensor Replacement (Chassis Cab Rear Tank)
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .