Right Side Gear Backlash Adjustment

1. If necessary, remove the following from the differential case:
   1. The pinion lock shaft bolt
   2. The pinion shaft
   3. The differential pinion gears
   4. The differential pinion gear thrust washers
   5. The left side locking differential side gear cam unit and clutch disc assembly
2. Install the differential side gear shim into the right side of the differential case.
3. Install the locking differential side gear and clutch disc assembly.
4. Align the openings of the differential pinion gears and the differential pinion gear thrust washers to the pinion shaft opening in the differential case.
NOTE:
• Press down on the locking differential side gear and install the pinion shaft.
• If the side gear cannot be pressed down far enough to install the pinion shaft, replace the side gear shim with a thinner shim.
5. Install the differential pinion gears with the differential pinion thrust washers into the differential case.
NOTE:

Tighten the pinion shaft lock bolt finger tight.

6. Install the pinion shaft lock and the bolt.
7. Rotate the differential pinion gear so that one of the teeth is pointing downward, square to the ring gear flange.

8. Install a brass drift between the locking differential side gear and the pinion shaft.

9. Press the brass drift in enough in order to compress the clutch discs.

10. Measure the backlash of the pinion gear and the right side gear by doing the following:

    1. Install the J-7872  base (1) and the J-8001  indicator (2) to the ring gear flange.
    2. Place the contact pad of the J-8001  indicator (2) on one of the teeth of the pinion gear closest to the pinion shaft lock bolt and zero the gauge.
    3. Pull the pinion gear firmly into the differential case seat.
    4. Rotate the pinion gear back and forth.
    NOTE:
    • If the backlash is greater than, install a thicker locking differential clutch disc thrust washer and recheck the backlash.
    • If the backlash is less than, install a thinner locking differential clutch disc thrust washer and recheck the backlash.
    5. The backlash between the differential pinion gear and the locking differential side gear cam unit should be:
       • For the 8.6 inch axle 0.076 - 0.229 mm (0.003 - 0.009 in).
       • For the 9.5 axle 0.051 - 0.203 mm (0.002 - 0.008 in).

Differential side gear shims are available in the following sizes:

Shim Sizes 

• 0.254 mm (0.010 in)
• 0.381 mm (0.015 in)
• 0.508 mm (0.020 in)
• 0.635 mm (0.025 in)
• 0.762 mm (0.030 in)
• 0.889 mm (0.035 in)
• 1.016 mm (0.040 in)
• 1.143 mm (0.045 in)