Removal Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
- Release the park brake.
- Disable the park brake cable adjuster. Parking Brake Cable Adjuster Disabling
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Parking Brake Rear Cable- Right Side (1) @ Parking Brake Cable Equalizer (2) - Disconnect
- NOTE:
Use an appropriate tool to depress the cable retainers to disengage the right parking brake rear cable from the frame.
Parking Brake Rear Cable- Right Side (1) @ Frame - Remove
Parking Brake Rear Cable- Right Side (1) @ Parking Brake Rear Cable Clip (2) - Disengage [2x]
Parking Brake Rear Cable Clip Bolt (1) - Remove
Perform the following procedure to remove the right parking brake rear cable (2) from the rear parking brake anchor backing plate (4).
- Compress the right parking brake rear cable spring (3) by pushing towards the rear parking brake actuator lever (1).
- Depress the locking tabs on the right parking brake rear cable.
- Pull the right parking brake rear cable out of the rear parking brake anchor backing plate (4).
- Remove the right parking brake rear cable (2) through the slot in the rear parking brake anchor backing plate.
- Parking Brake Rear Cable- Right Side (2) @ Rear Parking Brake Actuator Lever (1) - Remove
- Parking Brake Rear Cable- Right Side (2) - Remove
NOTE:
Note the routing of the right parking brake rear cable for proper installation. Pass the right parking brake rear cable through the parking brake rear cable guides and frame brackets as necessary.