Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Parking Brake Control Module (2) - Install
- Parking Brake Lever Nut (1) - Install and tighten [3x]25 N.m (18 lb ft)
- Connect the electrical connector.
Parking Brake Front Cable (3) - Install
- Parking Brake Front Cable Grommet (2) - Install
- Parking Brake Cable Retainer Nut (1) - Install and hand tighten
- Front Floor Panel Carpet - Install - Front Floor Panel Carpet Replacement
Floor Air Outlet Duct - Left Side (2) - Install - Floor Air Outlet Duct Replacement - Left Side
Body Hinge Pillar Trim Panel (1) - Install - Body Hinge Pillar Trim Panel Replacement
Parking Brake Lever Handle (2) - Install - Parking Brake Lever Handle Replacement
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Parking Brake Front Cable (1) @ Frame Bracket - Install
- Parking Brake Front Cable (1) @ Parking Brake Intermediate Cable (2) - Connect
- Enable the park brake cable adjuster. Parking Brake Cable Adjuster Enabling
- Verify that the vehicle will hold position with the parking brake pedal depressed.
- If additional adjustments need to be made, adjust the parking brake. Parking Brake Adjustment
CAUTION:
Refer to Fastener Caution .