LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Tires And Wheels) >> Repair Instructions >> Spare Wheel Hoist Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Spare Tire - Remove
  2. Raise and support the vehicle. Lifting and Jacking the Vehicle .
  3. If the secondary latch is engaged and the cable end is visible, perform the following procedure:
    1. Tighten the cable by turning the hoist shaft clockwise until you hear 2 clicks or feel it skip twice. You cannot overtighten the cable.
    2. Loosen the cable by turning the hoist shaft counterclockwise 3 or 4 turns.
    3. If the spare tire can be lowered, repeat steps 1 and 2 to see if the spare tire can be removed.
    4. If the spare tire cannot be lowered, turn the hoist shaft counterclockwise until approximately 15 cm (6 in) of cable is exposed.
    5. Raise and support the vehicle. Lifting and Jacking the Vehicle
    6. Place a transmission jack, or equivalent, under the spare tire.
    7. Position the center of the transmission jack under the secondary latch release button at the center of the spare tire. Arrange the arms of the transmission jack so they will support the tire after it has been released.
    8. Raise the jack until the spare tire stops moving upward and is firmly held in place, releasing the secondary latch.
    9. Lower the tire. If the spare tire is hanging by the cable, turn the hoist shaft counterclockwise until the tire is low enough to remove.
  4. If the secondary latch is engaged and the cable end is not visible, perform the following procedure:
    1. Raise and support the vehicle. Lifting and Jacking the Vehicle
    2. Place a transmission jack, or equivalent, under the spare tire.
    3. Position the center of the transmission jack under the secondary latch release button at the center of the spare tire. Arrange the arms of the transmission jack so they will support the tire after it has been released.
    4. Raise the jack until the spare tire stops moving upward and is firmly held in place, releasing the secondary latch.
    5. Lower the tire and remove it from the jack.
  5. GM4848393

    Spare Wheel Hoist Shaft Pin Retainer (1) - Remove

  6. Spare Wheel Hoist Shaft Pin (2) - Remove
  7. GM4848421

    Spare Wheel Hoist Shaft (1) @ Spare Wheel Hoist (2) - Separate

  8. GM4848475

    Spare Wheel Hoist Bolt (1) - Remove

  9. GM4848478

    Spare Wheel Hoist (1) - Remove

scientia non olet · About LEMON Manuals