LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Engine Controls And Fuel - 6.0L (L96 LC8) - Repair Instructions) >> Repair Instructions >> Throttle Body Idle Air Flow Compensation Reset >> With Scan Tool

With Scan Tool

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Select: Module Diagnostics
  3. Select: Engine Control Module
  4. Select: Configuration/Reset Functions
  5. Select: Learn Functions
  6. Select: Idle Learn
  7. Follow the instructions on the scan tool.
  8. Verify the scan tool parameter: Throttle Body Idle Air Flow Compensation = 0%
    • If greater than 0 

      Repeat step 1

    • Go to next step: If 0 
  9. Engine - Idling - At normal operating temperature
  10. Verify the scan tool parameter: Engine Speed = -100 to +200 RPM of the Desired Idle Speed
    • {Test failed 1 time(s)}If not in the specified range 
    1. Engine idling. - For greater than 3 min
    2. Ignition/Vehicle - Off - For greater than 1 min
    3. Engine idling. - For greater than 3 min
    4. Repeat step 9
    • {Test failed 2 time(s)}If not in the specified range 
    1. Perform the following action: Road test the vehicle.
    2. Vehicle Speed - Greater than 70 km (44 mi)
    3. Decelerate - For 2 s
    4. Repeat step 10.2 - 3 times
    5. Engine idling. - For greater than 3 min
    6. Repeat step 9
    • Go to next step: If in the specified range 
  11. All OK.
scientia non olet · About LEMON Manuals