LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Engine Controls And Fuel - 6.0L (L96 LC8) - Repair Instructions) >> Repair Instructions >> Evaporative Emission System Cleaning >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Use the Evaporative Emission (EVAP) System Tester GE 41413-A  in order to provide a clean, dry, low pressure nitrogen gas source. Do not substitute any other pressurized source, gas or otherwise. Damage may result to the EVAP system, test equipment or cause a safety risk.

    NOTE:

    Proceed with the following procedure only if referenced by an evaporative emission (EVAP) diagnostic or repair procedure.

  1. Turn OFF the ignition.
  2. Remove the EVAP canister purge valve. Evaporative Emission Canister Purge Solenoid Valve Replacement 
  3. Lightly tap the EVAP canister purge valve on a hard surface.
  4. Inspect for carbon particles exiting either of the vacuum ports.
    • If no carbon particles were detected, but a blockage was detected during a diagnostic procedure, install the original EVAP canister purge valve. Continue with the cleaning procedure.
    • If carbon particles are found during the inspection procedure, continue with the cleaning procedure.
    • If a diagnostic procedure directed you to replace the EVAP canister purge valve and no carbon particles were detected, replace the EVAP canister purge valve. Return to the published service procedure.
scientia non olet · About LEMON Manuals