Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Lubricate the camshaft position sensor seal (1) with clean engine oil. Adhesives, Fluids, Lubricants, and Sealers
Install the camshaft position sensor (1) to the engine front cover.
Connect the electrical connector (4) to the camshaft position sensor.
- Position the camshaft position sensor wire bracket (3).
- Connect the electrical connector (2) to the camshaft position actuator magnet.
- Install the engine front cover bolts (1) and tighten to 25 N.m (18 lb ft).
Connect the electrical connector (1).
- Crankshaft Balancer - Install - Crankshaft Balancer Replacement
CAUTION:
Refer to Fastener Caution .