Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Spring U-Bolt(1) - Install NEW[2x]
Rear Spring Anchor Plate(3) - Install
- Rear Spring U-Bolt Washer(2) - Install[4x]
- Rear Spring U-Bolt Nut(1) - Install and tighten - Rear Leaf Spring Replacement (Chassis Cab) , or Rear Leaf Spring Replacement (Except Chassis Cab)
- Remove the jack stand.
- Lower the vehicle.
WARNING:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fasteners could cause damage to the vehicle, component, or bodily injury.