Stator Shaft Support Installation
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Stator Shaft Support Procedure Align the bolt hole indicated by the arrow with the arrow that is cast into the case and push down to seat. |
| 2 | Stator Shaft Support Bolt M8 x 33 mm [9x]
CAUTION:
Refer to Fastener Caution . Procedure Tighten the bolts in the sequence shown. Tighten in sequence 35 N.m (26 lb ft) |
| 3 | Turbine Shaft Seal
NOTE:
Install a NEW seal. |