Case Extension Disassemble
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
- DT-26941 Bushing and Bearing Remover
- DT-38734 Intermediate Spring Compressor Adapter
- DT-45124 Removal Bridge
- DT-45124-9 Puller Leg
Equivalent regional tools:Special Tools
Use DT-47693-2 compressor and an arbor press to install the retaining ring.
- 1-2-3-4-5-Reverse Clutch Piston Dam Retaining Ring (1) - Remove and DISCARD
- 1-2-3-4-5-Reverse Clutch Piston Dam (2) - Remove
- 1-2-3-4-5-Reverse Clutch Piston Dam Seal (3) - Remove and DISCARD
- 1-2-3-4-5-Reverse Clutch Piston Inner Seal (4) - Remove and DISCARD
- 1-2-3-4-5-Reverse Clutch Piston O-Ring Seal (5) - Remove and DISCARD
- 1-2-3-4-5-Reverse Clutch Piston Return Spring (6) - Remove
1-2-3-4-5-Reverse Clutch Piston (1) - Remove
- 1-2-3-4-5-Reverse Clutch Piston Outer Seal (2) - Remove and DISCARD
- 1-2-3-4-5-Reverse Clutch Piston Inner Seal (3) - Remove and DISCARD
- Assemble special tools to use to remove the bearing.
- Ensure the feet of DT-26941 Bushing and Bearing Remover are properly engaged with the bearing.
- Output Shaft Bearing (4) - Remove
Automatic Transmission Case Extension Hole Plug (1) - Remove [2x]
CAUTION:
Refer to Seal Reuse Caution .
CAUTION:
Refer to Seal Reuse Caution .