Intermediate Side Door Trim Panel Replacement

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Rear Side Door Pull Handle Replacement
1	Rear Side Door Inside Handle Bolt Cap Procedure Use a plastic trim tool to disengage the integral retaining tabs on the rear side door inside handle bolt cap from the rear door trim plate.
2	Rear Door Inside Handle Bezel Bolt [2x] CAUTION: Refer to Fastener Caution . Tighten 1.9 N.m (17 lb in)
3	Rear Side Door Trim Plate Procedure Using a flat-bladed plastic trim tool, partially remove the trim plate. { If equipped } Disconnect the electrical connector. Transfer parts as necessary.
4	Intermediate Side Door Trim Panel Procedure Use an appropriate trim tool to carefully disengage the retainers around the outside edges of the lower portion of the door trim panel. Use a long flat bladed tool to carefully release the door trim panel out of the retainers around the window opening. Transfer components as necessary.