Removal Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Crankshaft Balancer (2) - Remove - Crankshaft Balancer Replacement
- Install EN-51096 crankshaft rear seal remover onto GE-23907-1 slide hammer.
Slide the small bend of EN-51096 crankshaft rear seal remover between the lip of the front seal and crankshaft. Ensure that the small bend of EN-51096 crankshaft rear seal remover engages the rear side of the front seal (1). While rotating EN-51096 crankshaft rear seal remover and GE-23907-1 slide hammer around the seal, use the slide hammer to remove the seal.
NOTE:
EN-51096 crankshaft rear seal remover has two ends. The end with the small bend will be used to remove the seal.