LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Mechanical - 4.3L (LV1)) >> Repair Instructions - On Vehicle >> Camshaft Position Actuator Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Starter - Remove - Starter Replacement (LV1)
  2. GM5001787Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    J 42386-A  Flywheel Holding Tool (1) - Install

    1. Bolt - M10 - 1.5 x 120 mm - Install and tighten50 N.m (37 lb ft)
    2. Bolt - M10 - 1.5 x 45 mm - Install and tighten50 N.m (37 lb ft)
  3. GM5022272Courtesy of GENERAL MOTORS COMPANY

    Camshaft Position Actuator Magnet (1) - Remove - Camshaft Position Actuator Magnet Replacement

  4. GM4865494Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    Refer to Camshaft Position Actuator Removal and Installation Warning .

    CAUTION:

    The camshaft position actuator solenoid valves must be kept parallel to the engine front cover during removal and installation. The camshaft position actuator solenoid valves can be damaged if they become wedged or stuck during this process.

    NOTE:

    The CPA solenoid valve must be Discarded and replaced with a NEW valve.

    Camshaft Position Actuator Solenoid Valve (1) - Remove and DISCARD

scientia non olet · About LEMON Manuals