Crankshaft Front Oil Seal Removal

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Crankshaft Front Oil Seal Procedure Install EN-51096 crankshaft rear seal remover onto GE-23907-1 slide hammer. NOTE: EN-51096 crankshaft rear seal remover has two ends. The end with the small bend will be used to remove the seal. Slide the small bend of EN-51096 crankshaft rear seal remover between the lip of the front seal and crankshaft. Ensure that the small bend of EN-51096 crankshaft rear seal remover engages the rear side of the front seal (1). While rotating EN-51096 crankshaft rear seal remover and GE-23907-1 slide hammer around the seal, use the slide hammer to remove the seal. Special Tools EN-51096 Crankshaft Rear Seal Remover GE-23907-1 Slide Hammer For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Crankshaft Front Oil Seal

Procedure

Install EN-51096 crankshaft rear seal remover onto GE-23907-1 slide hammer.

NOTE:

EN-51096 crankshaft rear seal remover has two ends. The end with the small bend will be used to remove the seal.

Slide the small bend of EN-51096 crankshaft rear seal remover between the lip of the front seal and crankshaft. Ensure that the small bend of EN-51096 crankshaft rear seal remover engages the rear side of the front seal (1). While rotating EN-51096 crankshaft rear seal remover and GE-23907-1 slide hammer around the seal, use the slide hammer to remove the seal.

Special Tools

EN-51096 Crankshaft Rear Seal Remover
GE-23907-1 Slide Hammer

For equivalent regional tools, refer to Special Tools .