Crankshaft Balancer Removal

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Crankshaft Balancer Bolt Procedure Install the J-42386-A flywheel holding tool. Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation and tighten bolts to 50 N.m (37 lb ft). NOTE: Do not discard balancer bolt, it will be used later for installation. Special Tools J-42386-A Flywheel Holding Tool For equivalent regional tools, refer to Special Tools .
2	Crankshaft Balancer Assembly Procedure Install the EN-41816-2 crankshaft end protector, Install the EN-41816 crankshaft balancer remover. Using both tools remove the crankshaft balancer. Special Tools EN-41816 Crankshaft Balancer Remover EN-41816-2 Crankshaft End Protector For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Crankshaft Balancer Bolt
Procedure
Install the J-42386-A flywheel holding tool. Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation and tighten bolts to 50 N.m (37 lb ft).

NOTE:

Do not discard balancer bolt, it will be used later for installation.

Special Tools
J-42386-A Flywheel Holding Tool
For equivalent regional tools, refer to Special Tools .

Crankshaft Balancer Assembly

Procedure

Install the EN-41816-2 crankshaft end protector,
Install the EN-41816 crankshaft balancer remover.
Using both tools remove the crankshaft balancer.

Special Tools

EN-41816 Crankshaft Balancer Remover
EN-41816-2 Crankshaft End Protector

For equivalent regional tools, refer to Special Tools .