Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Brake Pedal(1) - Install
- CAUTION:
Refer to Fastener Caution .
Brake Pedal Bolt(1) @ Brake Pedal(2) - Install and tighten33 N.m (24 lb ft)
Power Brake Booster Nut(1) - Install and tighten[4x] - Power Brake Booster Replacement
- Lubricant @ Brake Pedal Pivot Pin - Apply - Adhesives, Fluids, Lubricants, and Sealers
Brake Pedal Push Rod (3) - Connect
- Brake Pedal Push Rod Retainer (2) - Install
- Brake Pedal Push Rod Retainer Bolt (1) - Install and tighten - Power Brake Booster Replacement
- Clip the wiring harness to the brake pedal.
Brake Pedal Position Sensor(1) - Install - Brake Pedal Position Sensor Replacement
- Calibrate the brake pedal position sensor. Brake Pedal Position Sensor Calibration
NOTE:
Ensure that the brake pedal push rod retainer is fully engaged in the groove of the brake pedal pivot pin.