Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
- Bench bleed the brake master cylinder. Brake Master Cylinder Bench Bleeding
Brake Master Cylinder(2) - Install
- Brake Master Cylinder Nut(1) - Install and tighten[2x]36 N.m (27 lb ft)
Remove the caps from the brake pipe fitting and the master cylinder port.
- Brake Pressure Modulator Valve Pipe Nut - Rear(2) - Install and tighten32 N.m (24 lb ft)
- Remove the caps from the brake pipe fitting and the master cylinder port.
- Brake Pressure Modulator Valve Pipe Nut - Front(1) - Install and tighten32 N.m (24 lb ft)
- Wiring Harness @ Brake Master Cylinder - Install
- Electrical Connector @ Brake Fluid Level Indicator Switch - Connect
- Front End Sheet Metal Diagonal Brace- Left Side - Install - Front End Sheet Metal Diagonal Brace Replacement - Left Side
- Bleed the brake system. Hydraulic Brake System Bleeding (Pressure) , or Hydraulic Brake System Bleeding (Manual)
CAUTION:
Refer to Fastener Caution .