Removal Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
- Disable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling .
Using a blunt-ended tool, push the leaf spring fasteners (2) inward through the access holes. The access holes are located on both sides of the steering wheel shroud.
Lift and partially remove the inflatable restraint steering wheel module from the steering wheel in order to expose the electrical connectors.
- Disconnect the connector-position assurance (CPA) retainers from the electrical connectors.
- Disconnect the electrical connectors from the inflatable restraint steering wheel module.
- Remove the inflatable restraint module from the steering wheel.
- Refer to Inflatable Restraint Module Handling and Scrapping .
WARNING:
After installation of the steering wheel airbag module to the steering wheel, slightly pull the module outward. If there is no give on the airbag module then it is secured correctly. If the airbag module is not fully attached personal injury could result.
WARNING:
WARNING:
Refer to SIR Warning .
NOTE:
Do not attempt to repair the inflatable restraint steering wheel module. The inflatable restraint steering wheel module is replaced only as an assembly.