Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Position the inflatable restraint module to the steering wheel.
- Connect the electrical connectors to the inflatable restraint steering wheel module.
- Connect the CPA retainers into the electrical connectors. Seat and lock the connections.
Position the alignment posts of the inflatable restraint module to the holes that are located on the steering wheel housing.
- Push the inflatable restraint module into the steering wheel in order to engage and in order to latch the 2 leaf spring fasteners (1).
- After installation, pull the sides of the inflatable restraint module in order to ensure that both leaf spring fasteners are engaged.
- Enable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling .
WARNING:
After installation of the steering wheel airbag module to the steering wheel, slightly pull the module outward. If there is no give on the airbag module then it is secured correctly. If the airbag module is not fully attached personal injury could result.