LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Heating And Cooling System) >> Repair Instructions >> Cooling System Draining and Filling (GE47716 LC8, LV1, L96) >> Draining Procedure

Draining Procedure

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

With a pressurized cooling system, the coolant temperature in the radiator can be considerably higher than the boiling point of the solution at atmospheric pressure. Removal of the surge tank cap, while the cooling system is hot and under high pressure, causes the solution to boil instantaneously with explosive force. This will cause the solution to spew out over the engine, the fenders, and the person removing the cap. Serious bodily injury may result.

  1. Park the vehicle on a level surface.
  2. Radiator Filler Cap - Remove
  3. Raise and support the vehicle. Lifting and Jacking the Vehicle
  4. Place a drain pan under the vehicle.
  5. Radiator Outlet Hose @ Radiator - Remove - Radiator Outlet Hose Replacement (LWN) , or Radiator Outlet Hose Replacement (LV1) , or Radiator Outlet Hose Replacement (L96, LC8) 
  6. Drain the cooling system.
  7. If a complete engine block drain is required, remove the engine block coolant drain plugs.
  8. { If equipped }Engine Coolant Heater - Remove - Coolant Heater Replacement (LWN) , or Coolant Heater Replacement (LV1, L96, LC8) 
  9. Inspect the coolant.
  10. Follow the appropriate procedure based on the condition of the coolant.
    • Normal in appearance - Follow the filling procedure.
    • Discolored - Follow the flush procedure. Refer to Flushing .
scientia non olet · About LEMON Manuals