LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Lighting System) >> Diagnostic Information and Procedures >> DTC C0277 or C0890 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify the scan tool Brake Pedal Position Sensor Learned Release Position parameter, located in the BCM Chassis Control Data display, is within 0.1 V of the Brake Pedal Position Sensor parameter when the brake pedal is fully released.
    • Go to next step: If the difference is less than 0.1 V 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • Go to next step: If the DTC does not set 
  5. All OK.
scientia non olet · About LEMON Manuals