LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Cellular, Entertainment, And Navigation System) >> Diagnostic Information and Procedures >> DTC B1025, B1035, B1045, or B1055 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    Some circuits supply audio signals to more than one speaker. It may be necessary to disconnect all speakers on the affected audio circuit when performing circuit tests.

  1. Ignition OFF, disconnect the harness connector at the appropriate speaker.
  2. Radio ON, test for 5.0 - 7.5 volts between the signal circuit terminal A and ground.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the radio.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
  3. Test for 5.0 - 7.5 volts between the signal circuit terminal B and ground.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the radio.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
  4. If all circuits test normal, test or replace the speaker.
scientia non olet · About LEMON Manuals