Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
- Position the battery positive cable in the engine compartment.
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Battery Positive Cable(2) - Install
- Battery Positive Cable Nut(1)@Starter Solenoid(3) - Install and tighten14 N.m (124 lb in)
- Lower the vehicle.
Battery Positive Cable Retainer Bolt (2) - Install and tighten10 N.m (89 lb in)
- Battery Positive Cable Retainer(1) - Engage
Battery Positive Cable(2) - Install
- Battery Positive Cable Nut(1) - Install and tighten15 N.m (11 lb ft)
- Install the engine cover. Engine Cover Replacement
Battery Positive Cable(3) - Install
- Battery Positive Cable Nut(2) - Install and tighten10 N.m (89 lb in)
- Accessory Wiring Junction Block Cover(1) - Install
Battery Positive Cable Retainer(1) - Engage[4x]
Battery Positive Cable(2) - Install
- Battery Positive Cable Fastener(1) - Tighten13 N.m (115 lb in)
- Battery Positive Cable Retainer(3) - Engage[3x]
Air Cleaner Assembly(4) - Install - Air Cleaner Assembly Replacement
Coolant Recovery Reservoir(1) - Install - Coolant Recovery Reservoir Replacement (LV1)Coolant Recovery Reservoir Replacement (L96, LC8)
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (Single Battery) Battery Negative Cable Disconnection and Connection (Dual Battery)
CAUTION:
Refer to Fastener Caution