Component Testing
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition/Vehicle - Off
- Remove the appropriate component: T8 Ignition Coil - Leave the electrical connector connected.
- Install the special tool: J-26792 Ignition Spark Tester
- Engine - Running
- Verify there is spark at the tool.
- If there is no spark
Replace the component: T8 Ignition Coil
- Go to next step: If there is spark
- If there is no spark
- All OK.
NOTE:
Circuit/System Testing must be performed before proceeding with Component Testing.
NOTE:
An erratic or weak spark is considered a no spark condition.