LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Automatic Transmission - 6L90 (MYD) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Output Carrier Assembly Overhaul

Output Carrier Assembly Overhaul

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
GM1555299Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Output Carrier Front Sun Gear Thrust Bearing Assembly
2 Center Support Roller Bearing
CAUTION:

Do not reuse the center support roller bearing. Install a NEW center support roller bearing. Reusing an old bearing may result in damage to the output carrier.

NOTE:

The thick side of the bearing shell faces up.

Special Tools

  • DT-47857  Bearing Installer
  • J-6125-B  Slide Hammer
  • J-8092  Driver Handle
  • J-23129  Universal Seal Remover

Equivalent regional tools:Special Tools
3 Output Carrier Front Sun Gear
CAUTION:

Install the gear chamfer side up. Failure to install the gear chamfer side up may result in transmission damage.

4 Output Carrier Front Sun Gear Rear Thrust Bearing Assembly
5 Output Carrier Rear Sun Gear
CAUTION:

Install the gear chamfer side up. Failure to install the gear chamfer side up may result in transmission damage.

6 Output Carrier Rear Sun Gear Bearing Assembly
NOTE:

Inspect for damage only. Do not remove. The bearing assembly is not a serviceable component.