Upper to Lower Control Valve Body Assembly Assemble
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Upper to Lower Control Valve Body Assembly Assemble
| Callout | Component Name |
|---|---|
| 1 | Control Valve Body Ball Check Valve [8x]
CAUTION:
Do not use any type of grease or other material to hold the check ball valves in place during assembly. Grease will cause the valves to not operate properly, resulting in damage to the transmission.
NOTE:
For additional information regarding ball check valve location. Ball Check Valve Locations |
| 2 | Control Valve Body Spacer Plate
CAUTION:
Do not use the old spacer plate. Install a NEW spacer plate. Reusing an old spacer plate may cause internal transmission leaks and transmission damage. |
| 3 | Control Valve Lower Body
NOTE:
Turn the valve body assembly over after installing to upper body. |
| 4 | Control Valve Upper Body Bolt M5 x 36 [12x]
CAUTION:
Refer to Fastener Caution . Tighten in sequence 8 N.m (71 lb in). |