Center Support, Output Carrier and Output Shaft Removal
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Center Support Retaining Ring
WARNING:
Use care when removing or installing the retaining ring. Ensure the J 45126 and DT 47773 are installed properly onto the retaining ring or bodily injury may occur.
NOTE:
To release tension on the retaining ring, place the retaining ring flat on the floor and step on it, then remove the tool. Special Tools
Equivalent regional tools: Special Tools |
| 2 | Center Support |
| 3 | Output Carrier Assembly and Output Shaft Assembly
CAUTION:
Ensure the DT 47786 is completely threaded into the output shaft assembly. Due to the weight of the assembly, incomplete threading may cause the assembly to break free from the DT 47786, causing component damage. Special Tools DT-47786 Output Carrier/Shaft Lifting Tool Equivalent regional tools: Special Tools |
| 4 | Output Shaft Thrust Bearing |