1 - 2 - 3 - 4 and 3 - 5 Reverse Clutch Bearing Assembly Replacement
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
1 - 2 - 3 - 4 and 3 - 5 Reverse Clutch Bearing Assembly Replacement
| Callout | Component Name |
|---|---|
| 1 | 1-2-3-4 and 3-5-Reverse Clutch Bearing
CAUTION:
Install the NEW bearing assembly with the seal side up. Improper installation of the bearing may cause damage to the transmission.
CAUTION:
Do not use a hammer or other striking tool that may cause damage to the bearing and housing. Use care to ensure the bearing is installed slowly and evenly using an arbor press supporting the inner hub. Do not support by the housing or fracture will result.
CAUTION:
Do not reuse the bearing. Install a NEW bearing. Reusing an old bearing may cause damage to the transmission. Specification Install the bearing flush to 0.3 mm below the thrust surface. Special Tools
Equivalent regional tools:Special Tools |