Apply Compressed Air and Measurement

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Install the DT-47868-2 base adapter onto the torque converter housing. Install DT-47868-1 travel weight and DT-47868-3 travel weight adapter onto the 1 - 2 - 3 - 4 clutch backing plate. Install the GE-26900-13 magnetic base onto DT-47868-2 base adapter. Attach the GE-8001 dial indicator set to the GE-26900-13 magnetic base. Special Tools DT-47868-1 Clutch Pack Travel Weight DT-47868-2 Magnetic Base Adapter DT-47868-3 Clutch Travel Weight Adapter GE-8001 Dial Indicator Set GE-26900-13 Magnetic Base For equivalent regional tools, refer to Special Tools .
1	Compensator Feed Fluid Passage Procedure Apply compressed air to the compensator feed fluid passage. Zero out the dial indicator GE-8001 dial indicator set.
2	1-2-3-4 Clutch Apply Passage Procedure While Applying compressed air to the compensator feed fluid passage, simultaneously apply compressed air to the 1-2-3-4 clutch apply passage. Do this at least 3 times and observe the dial indicator measurement each time. Refer to Clutch Backing Plate Retaining Ring Specifications .

Callout

Component Name

Preliminary Procedures

Install the DT-47868-2 base adapter onto the torque converter housing.
Install DT-47868-1 travel weight and DT-47868-3 travel weight adapter onto the 1 - 2 - 3 - 4 clutch backing plate.
Install the GE-26900-13 magnetic base onto DT-47868-2 base adapter.
Attach the GE-8001 dial indicator set to the GE-26900-13 magnetic base.

Special Tools

DT-47868-1 Clutch Pack Travel Weight
DT-47868-2 Magnetic Base Adapter
DT-47868-3 Clutch Travel Weight Adapter
GE-8001 Dial Indicator Set
GE-26900-13 Magnetic Base

For equivalent regional tools, refer to Special Tools .

Compensator Feed Fluid Passage

Procedure

Apply compressed air to the compensator feed fluid passage.
Zero out the dial indicator GE-8001 dial indicator set.

1-2-3-4 Clutch Apply Passage
Procedure
While Applying compressed air to the compensator feed fluid passage, simultaneously apply compressed air to the 1-2-3-4 clutch apply passage. Do this at least 3 times and observe the dial indicator measurement each time. Refer to Clutch Backing Plate Retaining Ring Specifications .