LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P2537 (6L90) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the Automatic Transmission Assembly. Install the DT-47825-10  Jumper harness to the X1 vehicle wire harness connector.
  2. Ignition ON.
  3. Verify a test lamp illuminates between ignition the circuit terminal 9 and ground.
    • If the test lamp does not illuminate. 
    1. Ignition OFF remove the test lamp, disconnect the harness connector at the K9 Body Control Module.
    2. Test for infinite resistance between the ignition circuit and ground.
      • If less than infinite resistance, repair the short to ground in the circuit.
      • Go to next step: If infinite resistance
    3. Test for less than 2 Ω on the ignition circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the Body Control Module.
    • Go to next step: If the test lamp illuminates 
  4. Replace the Transmission Control Module.
scientia non olet · About LEMON Manuals