LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Engine Controls And Fuel - 6.0L (L96 LC8) - Diagnostic Information And Procedures (2 Of 2)) >> Diagnostic Information and Procedures >> Inspection/Maintenance (I/M) System DTC Table

Inspection/Maintenance (I/M) System DTC Table

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
System DTCs Required to Set System Status to YES
If an I/M System Status indicator did NOT update to YES during the Inspection/Maintenance Complete System Set Procedure , review each indicator and reference this table to determine each DTC associated with the I/M System Status Indicator. Each DTC listed below has specific conditions that must be met for the diagnostic to run. Included within the conditions are additional DTCs which, if set, may inhibit the DTCs listed below from running. Reviewing and operating the vehicle within the Conditions for Running for each DTC listed below will allow the I/M System Status Indicators to transition to YES.
Catalyst DTC P0420 or P0430
EVAP
Fuel Systems DTC P219A or P219B 
Oxygen Sensor DTC P0133, P013A-P013F, P014A, P014B, P0153, P015A-P015D, or P2270-P2273
Oxygen Sensor Heater DTC P0030-P0032, P0036-P0038, P0050-P0054, P0056-P0060, P0135, P0141, P0155, or P0161
Camshaft Position DTC P0010, P0011, P2088, or P2089