LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Engine Controls And Fuel - 6.0L (L96 LC8) - Diagnostic Information And Procedures (2 Of 2)) >> Diagnostic Information and Procedures >> DTC P0685-P0687, P0689, P0690, or P1682 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify no other DTCs are set.
    • Go to next step: If no other DTCs are set 
  3. Ignition - Cycle Off and On & Cycle On and Off

    Verify a click can be heard or felt at the component when the scan tool control function was commanded: KR75 Engine Controls Ignition Relay

    • If a click cannot be heard or felt 

      Refer to: Circuit/System Testing

    • Go to next step: If a click can be heard or felt 
  4. Verify the following parameters are within 3 V of each other:
    • Ignition 1 Signal
    • Engine Controls Ignition Relay Feedback Signal
    • If not within 3 V of each other 

      Refer to: Circuit/System Testing

    • Go to next step: If within 3 V of each other 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC does not set 
  6. All OK.
scientia non olet · About LEMON Manuals