Conditions for Running the DTC

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.

Before the ECM can report that DTC P0106 failed, DTCs P0112, P0113, P0117, and P0118 must run and pass.
DTCs P0106, P0107, P0108, P0101, P0102, P0103, P0111, P0112, P0113, P0114, P0116, P0117, P0118, P0119, P0128, P0335, P0336, or P111E are not set.
The engine speed is between 450-5, 600 RPM.
The engine coolant temperature (ECT) sensor is between -7 to 129°C (19 to 264°F).
The intake air temperature (IAT) sensor is between -20 to 125°C (-4 to 257°F).
The DTC runs continuously when the above conditions are met.
OR
Before the ECM can report that DTC P0106 failed, DTCs P0107, P0108, P2228, and P2229 must run and pass.
DTCs P0106, P0107, P0108, P2227, P2228, P2229, P2230, or P2610 are not set.
The ignition is ON, engine OFF.
The time between the previous drive cycle and the current ignition cycle is greater than 5 s.