Conditions for Running the DTC

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.

P0010, P2088, P2089

Ignition Voltage = Greater than 11 V
Ignition Switch Position = Run/Crank
Camshaft Position Actuator Solenoid Valve = On

Frequency the DTC runs = Continuously - After the running conditions are met

P0011

DTC P0010, P0016, P0335, P0336, P0340, P0341 = Not set
Ignition Voltage = Greater than 11 V
Engine = Running
Desired Camshaft Position = Does not vary greater than 7. 5° - For greater than 2 s
Camshaft Position Actuator = Enabled
Power Take-Off Switch = Off - If equipped

Frequency the DTC runs = Continuously - After the running conditions are met